M-Struts - Mechanical "Gas Spring"

M-Struts resembles a conventional compression gas spring. From its appearance, you cannot tell the difference, but inside is an ordinary wire compression spring.

SolidComponents^TM

Ideal for suspension of tools, hoses, etc. The surface is electrogalvanised.
If ordered, the pins are also on stock furnished painted either black or white. These pins will be painted over a galvanized surface.

SolidComponents^TM

DIN 988

Shim and support washers are flat washers used in combination where axial clearance must be offset. This might be on a shaft where there is a locking ring/bearing, between which clearance must be offset. By combining washers of different thicknesses you can precisely offset the clearance.
Material : St.2 K 50 DIN 1624 Hardness 170-225 HV 10
Surface is phosphatised and oiled.

SolidComponents^TM

DIN 988

Shim and support washers are flat washers used in combination where axial clearance must be offset. This might be on a shaft where there is a locking ring/bearing, between which clearance must be offset.
By combining washers of different thicknesses you can precisely offset the clearance.

SolidComponents^TM

Material: Din 17222 C 75


Wavy spring washers are used where axial clearance needs to be offset. This could be offsetting a small amount of clearance for ball bearings, flanges, washers, etc. Wavy spring washers are designed to have 2 waves.

SolidComponents^TM

Material: Din 17222 C 75


Curved spring washers are used where axial clearance needs to be offset.
This could be offsetting a small amount of clearance with a relatively light load.
All dimensions have 1 "curve". Cams with 1 "curve" allow the washer to be
pressed flat without the cam having reduced force as a result. It is, however, recommended that items always be sized so as to use less travel.

SolidComponents^TM

The material is spring steel DIN 1.1231



Designed to counteract noise, excess wear and vibration, especially at high speed, finger spring washers promote efficiency and smooth operation, reducing skidding wear on rotating elements, as in ball-bearing applications. They are also extremely useful in cases of unavoidable loose internal clearances due to special application conditions.
Material: High-carbon finely tempered spring st

SolidComponents^TM

The material is stainless 1.4310 or spring steel DIN 1.1231




Wave springs washers are manufactured in high-carbon steel. Wave spring washers are normally used in thrust-loading applications for small deflections where radial space is limited. Part numbers with suffix ‘R’ are Stainless Steel

SolidComponents^TM